Technical Data

Sun Wood Parquet is currently available in four different formats:


The wear layer thickness is approx. 3.6 mm. As a rule, this can be sanded off at least twice, since about 0.6 to 0.9 mm of material are removed per cut. With a remaining useful layer of 1.5 mm the suitability is still given. The Sun Wood design topcoat disappears completely and the surface become “rustic oak”.


For the treatment of damaged areas we recommend our protective varnish “Sprühkönig Ansatzlos PLUS”.


  1. Remove grease and dirt from the floor
  2. Shake the spray can well before use
  3. Clean or reload the floor after at least 12 hours

Mechanical damage or deep scratches are repaired with a special wax. The protective layer again forms the protective lacquer.

Indoor climate

The indoor temperature should be between 18 °C and 24 °C! The relative humidity should be always between 30% and 65%! This almost always requires powerful room humidification during the heating period! For this purpose, cold humidifiers with integrated sterilization are recommended.

The installation of a FIDBOX registers the indoor climate in and around the parquet floor for years, it reports deviations from the correct climate and can be conveniently read out via mobile phone app.


Sun Wood multi-layer parquet elements according to ÖNORM EN 13489 up to a thickness of 1.2 cm are to be glued over their entire surface, from a thickness of 1.3 cm they may also be laid floating or nailed. When using a underfloor heating, the floor must be glued. Continue reading.

Fire protection

Reaction to fireFloating installation: Dfl-s1
Glue-down installation on screed: Cfl-s1
500 kg/m³ density, 9 mm thickness
Emission of formaldehydeE1
Emission of pentachlorphenole<5 x 10-6
Release of dangerous substancesFulfills demands of AgBB-scheme
Breaking strengthNPD
Thermal conductivity0.14 W/mK
Biological durabilityClass 1